إرسال موضوع جديد الرد على الموضوع  [ مشاركة واحده ] 
الكاتب رسالة
 عنوان المشاركة: تونيك كروشيه بغرزة جميلة وحواف مكشكشة بالباترون
مرسل: الأحد مارس 17, 2013 8:18 pm 
غير متصل
مراقب عام
مراقب عام
اشترك في: الاثنين إبريل 05, 2010 7:23 pm
مشاركات: 13047
مكان: المنصورة

تونيك كروشيه بغرزة جميلة وحواف مكشكشة بالباترون



تونيك كروشيه بغرزة جميلة وحواف مكشكشة بالباترون

بسم الله الرحمن الرحيم

صورة

Crochet tunic with lace pattern, flounce at the bottom and butterfly for decoration

Size: S - M - L - XL - XXL - XXXL
Materials: 550-600-650-700-800-900 g colour white

CROCHET HOOK SIZE 3 mm – or size needed to get 23 tr x 12 rows = 10 x 10 cm. When working pattern 1 repetition = approx. 3.5 cm in width x 4 cm vertically.

1.5-2 meter silk ribbon around the waist, approx. 10 mm wide in a suitable colour.

CROCHET INFO:
Replace first tr on every row with 3 ch.

PATTERN:
See diagrams A.1 and A.2.

DECREASE TIP (applies to neck and armhole):
Dec at beg of row as follows: Work sl sts over no of tr to be dec.
Dec at end of row as follows: When no of tr to be dec remains, turn.
--------------------------------------------------------

TUNIC:
Worked back and forth in 2 parts and sewn tog when finished.

FRONT PIECE:
Work 141-160-178-197-216-234 ch on hook size 3 mm with Cotton Viscose. Continue with 1 dc in 2nd ch from hook, then 1 dc in each of the next 6-4-8-6-4-8 ch, * skip 1 ch, 1 dc in each of the next 6 ch *, repeat from *-* the entire row = 121-137-153-169-185-201 dc. Continue pattern A.1 as follows: Diagram a over the first 9 dc, diagram b until 8 dc remain, then diagram c over these (= 15-17-19-21-23-25 repetitions in total on row). Repeat the 4 rows in diagram A.1 upwards until piece measures approx. 32 cm – finish after 4th row in diagram. REMEMBER THE CROCHET TENSION!
Then work diagram A.2 one time vertically. When A.2 has been worked, there are 92-104-116-128-140-152 tr on row. Then work 1 tr in every tr - READ CROCHET INFO.
When piece measures 46-47-48-49-50-51 cm, dec for armhole in each side on every row as follows – READ DECREASE TIP: 4 tr 1 time, 3 tr 0-0-1-1-2-3 times, 2 tr 0-1-1-3-3-4 times and 1 tr 1-3-4-4-5-4 times in each side = 82-86-90-94-98-102 tr remain on row.
When piece measures 53-54-56-57-59-60 cm, beg neck dec and finish each shoulder separately.
FIRST SHOULDER: Work tr back and forth over the first 28-30-31-33-34-36 tr in one side – AT THE SAME TIME dec towards the neck on every row: 3 tr 1 time, 2 tr 2 times and 1 tr 2 times = 19-21-22-24-25-27 tr remain on shoulder. When piece measures 64-66-68-70-72-74 cm, cut the thread.
OTHER SHOULDER: Work the same way as the first.

BACK PIECE:
Work as front piece up to and with armhole dec = 82-86-90-94-98-102 tr on row. Continue to work until piece measures approx. 62-64-66-68-70-72 cm. Now finish each shoulder separately as follows: Work 1 row with tr over the first 21-23-24-26-27-29 tr, turn, dec the first 2 tr and work the rest of row, cut the thread. Repeat on the other shoulder.

ASSEMBLY:
Sew shoulder seams edge to edge to avoid a chunky seam. Sew side seams edge to edge so that they are less visible.

FLOUNCE AT THE BOTTOM:
Work in the dc row at the bottom of body as follows (beg in one side):
ROUND 1: 1 dc in first dc, * 3 ch, skip 1 dc, 1 dc in next dc *, repeat from *-* the entire round, finish with 1 sl st in first dc.
ROUND 2: 2 ch, 1 dc in first ch-loop, * 4 ch, 1 dc in next ch-loop *, repeat from *-* the entire round, finish with 1 sl st in first dc.
ROUND 3: 2 ch, 1 dc in first ch-loop, * 4 ch, 1 dc in next ch-loop *, repeat from *-* the entire round, finish with 1 sl st in first dc.
ROUND 4: 2 ch, 1 dc in first ch-loop, * 5 ch, 1 dc in next ch-loop *, repeat from *-* the entire round, finish with 1 sl st in first dc.
ROUND 5: 2 ch, 1 dc in first ch-loop, * 5 ch, 1 dc in next ch-loop *, repeat from *-* the entire round, finish with 1 sl st in first dc.
ROUND 6: Work as follows in every ch-loop: 2 dc + 1 picot (= 3 ch, 1 dc in first ch) + 2 dc. Cut and fasten the thread.

EDGE AROUND THE ARMHOLES AND NECK:
Beg mid back of neck and mid under armhole.
ROUND 1: 1 dc in first st, * 3 ch, skip approx. ½ cm, 1 dc in next st *, repeat from *-* the entire round, finish with 1 sl st in first dc.
ROUND 2: Work as follows in every ch-loop: 1 dc + 1 picot (= 3 ch, 1 dc in first ch) + 1 dc. Cut and fasten the thread.

SILK RIBBON: Thread a silk ribbon in the row with eyelet holes at the top below the yoke – beg and end in the left side at the front and make a small bow.


BUTTERFLY - for decoration:

WINGS: Work 15 ch on hook size 3 mm. Work all rows from RS.
ROW 1: Work 3 triple tr in 6th ch from hook, 1 ch, 1 tr in next ch, 2 ch (on 2nd row beg working here), 2 triple tr in next ch, 1 triple tr in next ch, 3 ch, 1 sl st in next ch, 3 ch (on 3rd row beg working here), 1 triple tr in next ch, 2 triple tr in next ch, 1 ch, 1 tr in next ch, 2 ch, 3 triple tr in next ch, 5 ch, 1 sl st in last ch. Cut and fasten the thread.
ROW 2: Start by working 1 sl st in the second of the 2 ch from previous row (see 1st row), 1 ch, in next triple tr work as follows: 1 htr and 1 tr, in next triple tr work as follows: 1 tr (on 4th row beg working here), 1 ch, 1 dtr and 1 tr, in next triple tr work as follows: 1 tr and 1 htr, 1 ch, 1 sl st in the 1st of the 3 ch from previous row. Cut and fasten the thread.
ROW 3: Start by working 1 sl st in the third of the 3 ch from 1st row (see 1st row), 1 ch, in next triple tr work as follows: 1 htr and 1 tr, in next triple tr work as follows: 1 tr (on 5th row beg working here), 1 dtr, 1 ch, 1 tr, in next triple tr work as follows: 1 tr and 1 htr, 1 ch, 1 sl st in 1 ch from 1st row. Cut and fasten the thread.
ROW 4: Start by working 1 sl st in tr from 2nd row (see 2nd row), 1 ch, in next dtr work as follows: 1 dc, 1 ch and 1 dc, 1 ch, 1 sl st in next tr. Cut and fasten the thread.
ROW 5: Start by working 1 sl st in tr from 3rd row (see 3rd row), 1 ch, in next dtr work as follows: 1 dc, 1 ch and 1 dc, 1 ch, 1 sl st in next tr. Cut and fasten the thread.
BODY:
Work as follows with double yarn: 6 ch, 2 dc in the 2nd ch from hook (= head). Cut and fasten the thread. Sew the body on to the wings with the head up between the big wings.
Finish by working a row of sl sts along the edge of the big wings.
Sew the butterfly to the left side of yoke.

صورة

صورة

صورة






دورة تعلم الكروشيه من البداية وحتى الإحتراف

صورة



أعلى
رد مع اقتباس


إرسال موضوع جديد الرد على الموضوع  [ مشاركة واحده ] 

أقرا ايضا
بلوزة كروشيه صيفى طبقات مكشكشة بالباترون والخطوات المصورة
باترون فستان / تونيك كروشيه طبقات حريمى بالباترون والشرح بالعربى
شال كروشيه مثلث بغرزة روعه بالباترون
جاكت كروشيه حريمى بغرزة الزجزاج بالباترون
بوليرو كروشيه صيفى بالباترون بغرزة مخرمة روعه
باترون بونشو كروشيه حريمى بغرزة مخرمة بالباترون
بوليرو كروشيه بغرزة مفرغه بالباترون والشرح بالعربى
جاكت كروشيه حريمى بغرزة مخرمة وكشكشة من الاطراف بالباترون
جاكيت كروشيه رجالى بغرزة الضفاير بالباترون والشرح بالتفصيل بالعربى
إسكارف كروشيه بغرزة الصدفة والعنقود بالباترون والشرح بالعربى مع الصور

تعليمات المشاركة
لا تستطيع كتابة مواضيع جديدة في هذا المنتدى
لا تستطيع كتابة ردود في هذا المنتدى
لا تستطيع تعديل مشاركاتك في هذا المنتدى
لا تستطيع حذف مشاركاتك في هذا المنتدى
لا تستطيع إرفاق ملف في هذا المنتدى
لهلوبه - أعلى

Powered by phpBB® Forum Software © phpBB Group
ترجم بواسطة phpBBArabia
phpbb_seo